- 1: Model number: 800-1
- 2: use the power supply. Ac 110V 60HZ 2: centrifugal capacity. 20 ml x 6
- 3: motor power. 25 W
- 4: transfer speed. 400-4000 r/min
- 5: relative centrifugal force. 1790 xg 6: timing range. 1-60 min or to often open
- Operation: Put the machine on a level and strong table and keep the working room clear 、dry and ventilated.
Indoor temperture5- 32℃ is ok Open the power supply and make sure the indicator lamp is light.
Shut the power switch. Open the cover of the machine, clear the rotor and container. -
Widely suitable for HOME use. Safe, compact and quiet in using
Product Description
✴It is often used to separate substances with different specific gravity in solution. Because the centrifugal force is far greater than gravity, the material with larger proportion will precipitate preferentially. Finally, the effect of complete separation of two or more substances is realized.
✴Specifications:
Power: 25W
Voltage: 110V/60Hz
Capacity: 20ml*6
Speed: 0-4000 rpm
Timer range: 0-60 minutes or always on
Separation coefficient: 1.960
Relative centrifugal force: 1790 x g
Test tube: 10.5 cm (h) 2 cm (diameter)
Please insert the tubes into the machine symmetrically, or will not work properly in an asymmetric state.
Please add a tube of clean water to achieve symmetrical operation if you have a single sample.
Please check the rotor for corrosion damage berfore operation.
Please balance the weight of the tubes down to about +/- 0.1 grams. If your opposing pairs of tubes are off by more than that, it starts making a lot of noise.
It has 3 adjustable speed ranges and a adequate timer (+/- 6 seconds).
Although it vibrates slightly at speeds <500 rpm, it smooths out and runs very nicely >1,000 rpm.
✴Packing list:
1 x Electric Centrifuge
6 x 20 ml test tube
1 x Screwdriver
1 x User Manual
✴Use precautions:
1. The instrument needs to be stored in a clean and tidy environment with good ventilation and suitable temperature.
2. When using a centrifuge, the test tube should be placed symmetrically, and the material placed in each test tube must be equal.
3. Before shutting down, it is necessary to turn off the power supply after lowering the speed.
Note: If there are any quality problems, please feel free to contact us.
